Export Packing a Flare Tip

Export Packing a Flare Tip

Our mobile packing team has done a great job again, this time with an over-sized load in South Wales; Export Packing a Flare Tip heading out to finish off a Flare Stack on an oil rig off the coast of Australia.

The steelwork is needed for the lifting to get it into the plane, as it’s too tall stood up, so it needs to be loaded on its side. However, the lifting at its final destination needs to be done with it stood upright. With the steel lugs on its side and two cranes, the case can be easily and safely rotated, while keeping the flare tip completely supported the whole time.

After the case is finished, it’s then a matter of getting it where it needs to go. With a case this large (456 x 387 x 384 cms), and when time is of the essence, the only option is the famous Antonov:

AntonovPlaneOpen

Share this post

Leave a comment

Your email address will not be published.